Description
This is an externally-powered Digimatic Indicator with a N-ch open drain NG, OK, +NG output.
- Dust-protected and protected against splashing water, complying with IEC 60529 (equivalent to IP54)
- Measures MAX/MIN/RANGE (run-out value).
- Saves three different Preset and Tolerance settings.
- Fast measurement frequency mode (detection cycle 50 times/s) for reliable measurement in the peak detection mode (MAX/MIN/RANGE)
- Calculation function Ax. Coefficient A freely definable, x = displacement of the plunger
- Analogue bar graph in the display (12 different scales switchable)
- GO/±NG tolerance judgment function
Specification
| PRESET 3x: | Yes |
| Digital/Analog: | Digital |
| Inch-Metric: | Inch/Metric |
| No. Lug back plate: |
543-283 |
| Range: | 0.5″/12.7 mm |
| Range: | 0,5″ |
| Digital step: | 0,00005″/0,001 mm |
| Max. Permissible Error E MPE: | 0,0001″/0,003 mm |
| Hysteresis: | 0,0001″/0,002 mm |
| H MPE (Hysteresis): | 0,0001″/0,002 mm |
| R MPE (Repeatability): | 0,0001″/0,002 mm |
| Measuring force: | ?2,5 |
| Type: | ASME/ANSI/AGD Standard |
| Protection: | IP54 |
| Display: | LCD, character height 8 mm |
| Max. response speed: | Unlimited |
| Measurement frequency (MAX/MIN/RANGE): | Standard mode: 100 times/s (plunger speed max. 0.1mm/s for peak measurement) |
| Alarm: | Counting value composition error, overflow error, tolerance limit setting error |
| Stem Ø: | 9,52 mm |
| Contact point: | Carbide ball, thread 4-48 UNF |
| Power supply: | 5 – 24 V DC / 100mA (max) |
| Delivered: | With signal cable 4 m. One end is fixed to the main unit. no connector is supplied for the other end. |
| ON/OFF: | Yes |
| Signal output: (+NG, OK, -NG): |
Yes |
| Signal input: No-voltage input, (PRESET_RECALL/ZERO, HOLD_RESET): |
Yes |
| MAX/MIN/RANGE: | Yes |
| ABS / INC (INC ZERO): | Yes |
| Function lock: | Yes |
| GO/±NG judgement via LED: | Yes |
| GO/±NG judgement: | Yes |
| Calculation function (with formula): | Yes |
| Counting direction switchable: | Yes |
